theperfectvasup.blogg.se

1. #WD MY BOOK EXTERNAL HARD DRIVE NOT WORKING CLICKING SOUND HOW TO#
2. #WD MY BOOK EXTERNAL HARD DRIVE NOT WORKING CLICKING SOUND DRIVER#
3. #WD MY BOOK EXTERNAL HARD DRIVE NOT WORKING CLICKING SOUND PORTABLE#
4. #WD MY BOOK EXTERNAL HARD DRIVE NOT WORKING CLICKING SOUND MAC#
5. #WD MY BOOK EXTERNAL HARD DRIVE NOT WORKING CLICKING SOUND WINDOWS#

If all USB ports are working fine then you need to check for the latest USB driver installed on the computer. Don’t use any USB hub to connect the device to the computer. If no USB port recognizes the device then, try another solution. If it is recognized by other USB ports then, there could be a hardware problem with one of the USB ports. : If the current USB port doesn’t detect the hard drive then, try to connect it with another USB port.

Sometimes, a very simple trick can fix an external hard disk not detecting a problem.

#WD MY BOOK EXTERNAL HARD DRIVE NOT WORKING CLICKING SOUND HOW TO#

How to fix External Hard Disk not Detected in Windows? Disconnect the power supply

#WD MY BOOK EXTERNAL HARD DRIVE NOT WORKING CLICKING SOUND WINDOWS#

“One of the USB devices attached to this computer has malfunctioned, and Windows does not recognize it for assistance in solving this problem, click this message.” When you try to access the data from the hard drive or USB device, you see the following USB Device Not Recognized error message: This happen when the USB port did not recognize the external USB drives.

#WD MY BOOK EXTERNAL HARD DRIVE NOT WORKING CLICKING SOUND PORTABLE#

These USB drives are portable and easy to handle, but sometimes you might face the Hard disk not detected a problem with Windows PC. are the easy way to store and transfer data from one computer to another.

#WD MY BOOK EXTERNAL HARD DRIVE NOT WORKING CLICKING SOUND MAC#

Questions? Comments? Have a fix? Post them below or e-mail us!īe sure to check us out on Twitter and the CNET Mac forums.USB devices like Hard Drives, Pen drives, and Memory Card, etc. Check with the manufacturer on how to do this, but it usually involves unplugging the device for a set amount of time, and pressing a combination of buttons or a small, hidden reset button on the device. Lastly, try resetting the device, since a firmware fault could cause communications and power management errors. Connect the drive directly to the Mac and avoid daisy-chaining it to other devices. In addition to ensuring the drive is getting adequate power, try checking the cables for the drive by swapping them out. Therefore, plug it in if you have a power supply for it (many bus-powered drives ship with an optional one). If the drive is not getting enough power (especially true with bus-powered devices) then the device may unmount and fail. In addition to buttons getting stuck, drives may also stop working because of power problems and connection problems. I would recommend placing the drive against a firm surface like a table and then tapping it firmly with one or two fingers, as if you were striking a piano key loudly. While hard drives park their heads when powered down, a violent shock can still cause physical damage. Be sure if you tap the drive that you do so firmly but not violently. Once this has been done, plug it back in and start it up again, and hopefully the device will be working. The quick fix for this is to turn off and unplug the MyBook, and then give it a few sharp taps around the power button to dislodge it. While hard drives can fail at times for odd reasons, in this instance it turned out to be a problem with the drive's enclosure.Īpparently the power button on the MyBook enclosure can get stuck, and since holding the power button on many devices is a way to reset them or otherwise send custom commands to the firmware, this could cause the MyBook to power up but then stop communicating properly with the computer. This problem started happening after the system had been using the drive successfully for a while, and had performed numerous Time Machine backups to it. The drive would appear to start mounting or otherwise be recognized by the system, but then seem to hang and not be recognized. Recently we received an e-mail from a MacFixIt reader who wrote in with a fix he found for his Western Digital MyBook external hard drive that had stopped working. In reality we do not recommend you "smack" your hard drive or other system components, but sometimes a little love tap or two can fix odd problems.